FREE EXPEDITED SHIPPING WHEN YOU ORDER TODAY
 

Charging the sleepbuds and the case

Charging the case

The battery-powered charging case stores and charges your sleepbuds while you’re not using them. When the case is empty, allow up to three hours to fully charge the case. When the sleepbuds are inside the case, charging time varies. When the case is fully charged and operating on battery power, you can fully charge the sleepbuds once. A single charge of the sleepbuds allows up to 16 hours of use.

Before charging, make sure the sleepbuds are at room temperature, between 41° F (5° C) and 113° F (45° C). You can use any compatible USB power source to charge the case. For best performance, however, use the provided USB power supply.

Connect the small end of the USB cable to the USB connector on the back of the case

Connect the other end to the USB power supply

Plug the USB power supply into an AC (mains) outlet. If necessary, attach the AC power adapter for your region

Charging the sleepbuds

The sleepbuds charge while they are in the case. Allow up to eight hours to fully charge the sleepbuds. A full charge of the sleepbuds allows up to 16 hours of use.

Align the charging contacts on the right sleepbud with the charging pins on the right side of the case

Place the sleepbud in the case until it magnetically snaps into place. The charging light for the right sleepbud blinks white

NOTE: If the charging light doesn’t blink white when you place the sleepbud in the case, the sleepbud may have been placed in the case incorrectly or your case battery may be depleted. Place the sleepbuds in the case again, then charge the case.

Repeat the steps to charge the left sleepbud

Wait for the sleepbuds' charging lights to slowly blink white, then close the case

Checking the case battery level

Open the lid of the charging case. The case battery lights glow as follows:

• ○ ○ ○ ○ 0% - 20%
• • ○ ○ ○ 20% - 40%
• • • ○ ○ 40% - 60%
• • • • ○ 60% - 80%
• • • • • 80% - 100%

While charging, the last lit battery light blinks white. When the charging case if fully charged, all battery lights glow solid white.

If the case isn't connected to power, the lights turn off after 30 seconds of inactivity.

Sleepbud charging lights

The charging lights for the sleepbuds are located on the inside rim of the charging case.

Blinking white
Waking up or going to sleep. Do NOT remove the sleepbuds from the case or close the case during this state
Slowly pulsing white
Charging
Solid white
Fully charged

Battery protection

The battery protection feature conserves the batteries of the sleepbuds when the battery of the case becomes depleted. The sleepbuds switch off when they have been left in a case with a depleted battery for a week.

To wake the sleepbuds, do the following:

  • Connect the case to power
  • Place the sleepbuds in the case
  • Wait for the sleepbuds' charging lights to slowly blink white then close the case
  • Open the case, wait for the sleepbuds' charging lights to slowly blink white again, then remove them from the case

Was this helpful?

Submit

Thank you for submitting your comments.