FREE EXPEDITED SHIPPING WHEN YOU ORDER TODAY
 

Pairing with a Bluetooth® device

pairing occurs when two bluetooth devices communicate with each other and establish a connection. a record of information about this connection is then stored in the memory of each device. once you pair a device with the soundlink® color bluetooth speaker, you should not have to pair it again. the speaker can pair with up to eight bluetooth devices. however, it can only connect to, and play audio from, two devices at a time.

To pair with a Bluetooth device, follow these steps:

with the bluetooth device and the soundlink® color speaker both turned on, press bluetooth on the speaker to make it discoverable. the bluetooth indicator on the speaker blinks blue to show that it's discoverable

Bluetooth

set your bluetooth device to "discoverable." this will allow your device to discover the soundlink® color speaker

locate the bluetooth device list in the user interface of your device. select "bose color soundlink" from the list

if your bluetooth device prompts you for a passcode, enter digits 0000 (four zeros) and press "ok." some devices also ask you to accept the connection

the speaker indicates pairing is complete when you hear an audible tone and the bluetooth indicator turns solid white

To connect to a previously paired device, follow these steps:

on the speaker, press power to turn it on. the bluetooth indicator flashes white

Power

on your mobile device, turn bluetooth on if it is not already on. the speaker indicates pairing is complete when you hear an audible tone and the bluetooth indicator remains solid white

note: if the speaker is in discoverable mode (blinking blue), and you want to go back into connecting mode, press bluetooth. the indicator blinks white and the soundlink® color speaker goes into connecting mode.

Bluetooth

Speaker memory

the soundlink® color speaker memory can hold up to eight paired devices. when the memory is full and an additional device is paired, the least recently used device is deleted from memory and replaced by the newly paired device.

to clear the memory of all devices, press and hold bluetooth for about 10 seconds until you hear a voice prompt/tone. all bluetooth devices are cleared from the speaker, and the soundlink® color speaker becomes discoverable.

Bluetooth

Was this helpful?

Submit

Thank you for submitting your comments.