FREE EXPEDITED SHIPPING AND FREE RETURN SHIPPING
 

Adjusting Acoustic Noise Cancellation

Using the control module

Acoustic Noise Cancellation reduces unwanted noise providing a clearer sound from the headset. You can adjust noise cancellation based on your listening preferences and environment.

The first time you power on your headset, noise cancellation is fully enabled. You can adjust the amount of noise cancellation with the ANC switch on the control module:

HIGH: Set the switch to "HIGH" for maximum quiet and noise cancellation across the entire spectrum. Best signal to noise ratio for radio and intercomcommunications.

 

MED: Optimized mode for quieter aircraft.

 

LOW: Best for interpersonal communication.

Using the tap control

Note: By default, Tap Control is disabled. To enable Tap Control, see Setting the control module operation switches.

When you need to focus on communication in the aircraft that is not coming through the intercom or Bluetooth connection, you can automatically set noise cancelling to Low on a single earbud by double-tapping that earbud.

Double-tap the earbud again to set noise cancelling in both earbuds to the Acoustic Noise Cancelling switch level—or move the control module switch to another position.

Additional notes:

  • Tap Control is not a touch control feature. You must firmly double-tap the earbud in order to activate the feature.
  • Since Tap Control changes the selected earbud's noise cancellation level to Low, Tap Control only works when the ANC switch on the control module is set to High or Medium. If the switch is already set to Low, Tap Control has no effect.

Was this helpful?

Submit

Thank you for submitting your comments.