Changing the image view

Applies to:

  • productshortname_dummy

To change the image view setting, follow these steps:

Turn the system on

on the remote, press source, and then use the up arrow or down arrow to select the source you want to adjust. press ok to confirm

on the remote, press the click pad to display the control frame

select the "image view" icon in the control frame by pressing the click pad while it is highlighted

press the right arrow to scroll through the different options

normal: leaves original video image unchanged.

auto-wide: fills width of the screen without cropping any content.

stretch 1: stretches video image evenly from the center.

stretch 2: stretches the edges of the video image much more than the center portion of the image.

zoom: enlarges the video image (press the up/down navigation buttons to vertically offset the image on your screen).

gray bars: places vertical gray bars on the left and right of a standard definition video image.

Was this helpful?


Thank you for submitting your comments.