SoundTouch soundbar system

Sold from 2017 - 2020

Help us provide the best support by confirming your product below
Select your product
Product image
Enter a search term in the field above.
Nothing found. Please enter a valid search (i.e., connection help, no audio from headphones, etc.).

Difficulty connecting the bass module

If you are unable to pair the wireless bass module to your system, try the following:

Be sure the system is able to turn on.

Try turning on the system using its remote control. If system fails to power on, see Product will not turn on.

Check for and install any available product updates.

Try resetting the bass module by disconnecting power for 30 seconds.

Disconnect the power cord from the back of the bass module or from the power outlet. Wait 30 seconds, then reconnect power and try again.

Clear the memory of the bass module, then try connecting to the soundbar again.

Your bass module remembers the last soundbar it tried to connect to so it can automatically connect. In case there is an issue with the bass module memory, clear it and try connecting again. On the back of the bass module, press and hold the button for about ten seconds until the light on the back of the bass module blinks white and then glows amber. For help connecting, see Connecting the bass module.

Button on the back of the bass module

Move wireless devices further away from the soundbar and bass module.

To prevent wireless signals from over-powering devices next to it, be sure to keep other wireless devices at least two feet away from the soundbar and the bass module.

Reset your product.

Much like rebooting a smartphone, your product might need to be reset on occasion to correct minor issues. For more info, see Resetting your product.

If using a wireless connection, try connecting the bass module with a wired connection.

Your bass module can connect wirelessly or with a wire. In situations where you cannot reposition the bass module or other wireless devices to avoid wireless interference, connect a shielded 3.5 mm cable from the Acoustimass / Bass output on the soundbar to the Acoustimass In connection on the bass module. If the issue no longer occurs when the bass module has a wired connection to the console, wireless interference was causing the issue. A shielded cable is recommended to avoid interference from other electronic devices. A 15-foot (4.5 m) shielded audio cable is available to order through Bose.

Disable any "channel bonding" or "40MHz mode" on the wireless router.

The "channel bonding" mode available on 802.11n wireless routers allows for the use of more bandwidth than Bose system is able to filter out. Turning off this mode or selecting the 20Mhz mode will allow the system to work around the Wi-Fi channel in use by the router.

The Acoustimass module and soundbar may need service.

If the steps provided do not resolve your issue, the Acoustimass module and soundbar may need service. Follow the link below for more information on how to service your product. Depending on your product and region, you will be provided a contact number or the ability to setup service online.

Click here to start service
    Was this article helpful?
    Thank you for your feedback!